EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2CSR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CSR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791453973	170 Count	351 Count	155 Count
1791452172	156 Count	324 Count	142 Count
1791450371	140 Count	295 Count	127 Count
1791448571	125 Count	270 Count	113 Count
1791446780	107 Count	247 Count	100 Count
1791444979	90 Count	223 Count	84 Count
1791441377	64 Count	166 Count	60 Count
1791439577	50 Count	135 Count	47 Count
1791437775	31 Count	91 Count	29 Count
1791435974	16 Count	39 Count	16 Count
1791434174	545 Count	1013 Count	483 Count
1791430572	518 Count	951 Count	459 Count
1791428771	503 Count	918 Count	446 Count
1791426970	489 Count	889 Count	433 Count
1791425178	471 Count	860 Count	421 Count
1791423377	457 Count	833 Count	408 Count
1791421576	446 Count	808 Count	399 Count
1791419775	432 Count	779 Count	386 Count
1791417974	417 Count	750 Count	373 Count
1791416174	404 Count	723 Count	361 Count
1791414373	388 Count	690 Count	347 Count
1791412572	371 Count	660 Count	331 Count
1791410771	352 Count	621 Count	314 Count
1791408971	324 Count	576 Count	287 Count
1791407170	301 Count	530 Count	266 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 1, 0

V_Ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)