EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9EPW-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9EPW-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791445792	4 Count	26 Count	0 Count
1791443991	3 Count	23 Count	0 Count
1791442191	2 Count	18 Count	0 Count
1791440390	1 Count	12 Count	0 Count
1791438590	0 Count	5 Count	0 Count
1791436788	83 Count	1006 Count	19 Count
1791434987	82 Count	1000 Count	19 Count
1791433187	81 Count	990 Count	19 Count
1791429593	75 Count	972 Count	19 Count
1791427793	74 Count	967 Count	19 Count
1791425992	73 Count	962 Count	19 Count
1791424191	72 Count	956 Count	19 Count
1791422390	71 Count	946 Count	19 Count
1791420589	70 Count	941 Count	19 Count
1791418788	69 Count	936 Count	19 Count
1791416988	68 Count	931 Count	19 Count
1791415187	67 Count	926 Count	19 Count
1791413386	66 Count	921 Count	19 Count
1791411586	65 Count	911 Count	19 Count
1791409785	64 Count	906 Count	19 Count
1791407992	59 Count	900 Count	19 Count
1791406191	58 Count	894 Count	19 Count
1791404391	57 Count	879 Count	19 Count
1791402590	56 Count	873 Count	19 Count
1791400789	55 Count	868 Count	19 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)