EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791449805	7 Count	28 Count	3 Count
1791448004	188 Count	1005 Count	81 Count
1791446202	184 Count	962 Count	78 Count
1791444401	181 Count	920 Count	76 Count
1791442600	172 Count	864 Count	73 Count
1791440798	164 Count	794 Count	71 Count
1791439013	148 Count	718 Count	69 Count
1791437212	136 Count	643 Count	66 Count
1791435409	133 Count	567 Count	64 Count
1791433608	117 Count	500 Count	61 Count
1791431807	114 Count	485 Count	59 Count
1791430006	110 Count	477 Count	56 Count
1791428204	106 Count	467 Count	54 Count
1791426403	102 Count	456 Count	51 Count
1791424602	98 Count	450 Count	48 Count
1791422800	95 Count	441 Count	46 Count
1791420999	91 Count	432 Count	43 Count
1791419197	88 Count	421 Count	41 Count
1791417413	85 Count	412 Count	39 Count
1791415612	81 Count	399 Count	36 Count
1791413810	78 Count	388 Count	34 Count
1791412009	74 Count	375 Count	31 Count
1791410208	71 Count	365 Count	29 Count
1791408406	67 Count	356 Count	26 Count
1791406605	64 Count	345 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)