EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771581450	228 Count	265 Count	223 Count
1771579650	208 Count	243 Count	204 Count
1771577848	189 Count	222 Count	186 Count
1771576048	162 Count	193 Count	160 Count
1771574247	109 Count	138 Count	108 Count
1771572446	45 Count	67 Count	45 Count
1771570645	907 Count	1035 Count	868 Count
1771568845	869 Count	984 Count	831 Count
1771567044	831 Count	912 Count	794 Count
1771565243	790 Count	854 Count	754 Count
1771563450	761 Count	826 Count	730 Count
1771561650	729 Count	792 Count	699 Count
1771559849	696 Count	758 Count	667 Count
1771558048	668 Count	728 Count	640 Count
1771556248	641 Count	698 Count	614 Count
1771554447	614 Count	668 Count	588 Count
1771552646	587 Count	639 Count	562 Count
1771550845	548 Count	596 Count	524 Count
1771549044	501 Count	545 Count	478 Count
1771547244	465 Count	506 Count	443 Count
1771545443	435 Count	473 Count	414 Count
1771543642	404 Count	440 Count	384 Count
1771541849	373 Count	410 Count	358 Count
1771540048	332 Count	366 Count	318 Count
1771538248	292 Count	320 Count	279 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)