EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP7TBU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1791510741	155 Count	830 Count	123 Count
1791509540	146 Count	777 Count	115 Count
1791508339	131 Count	718 Count	104 Count
1791507139	120 Count	662 Count	96 Count
1791505938	110 Count	619 Count	87 Count
1791504737	97 Count	576 Count	78 Count
1791503536	87 Count	527 Count	71 Count
1791502352	73 Count	458 Count	58 Count
1791501151	59 Count	380 Count	47 Count
1791499950	49 Count	304 Count	40 Count
1791498750	37 Count	223 Count	30 Count
1791497549	24 Count	151 Count	19 Count
1791496348	13 Count	77 Count	12 Count
1791495147	220 Count	1054 Count	175 Count
1791493946	201 Count	979 Count	159 Count
1791492745	187 Count	911 Count	148 Count
1791491544	174 Count	847 Count	137 Count
1791490342	158 Count	774 Count	124 Count
1791489141	145 Count	700 Count	113 Count
1791487940	130 Count	623 Count	101 Count
1791486740	117 Count	554 Count	91 Count
1791485539	106 Count	493 Count	82 Count
1791484338	94 Count	420 Count	72 Count
1791483137	81 Count	367 Count	62 Count
1791481936	70 Count	304 Count	54 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)