EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SV1SSF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775486618	60 Count	348 Count	47 Count
1775484815	50 Count	296 Count	38 Count
1775483011	44 Count	260 Count	33 Count
1775481208	39 Count	212 Count	29 Count
1775479404	32 Count	177 Count	23 Count
1775477601	24 Count	132 Count	16 Count
1775475798	18 Count	101 Count	11 Count
1775473994	14 Count	67 Count	8 Count
1775470384	4 Count	9 Count	2 Count
1775447570	143 Count	885 Count	123 Count
1775445766	138 Count	854 Count	119 Count
1775443963	131 Count	821 Count	114 Count
1775442160	126 Count	789 Count	110 Count
1775440356	121 Count	750 Count	106 Count
1775440157	120 Count	750 Count	106 Count
1775440143	124 Count	782 Count	109 Count
1775438339	119 Count	750 Count	106 Count
1775436536	112 Count	716 Count	102 Count
1775436498	112 Count	716 Count	102 Count
1775436473	112 Count	716 Count	102 Count
1775436465	112 Count	716 Count	102 Count
1775436412	112 Count	716 Count	102 Count
1775436383	112 Count	716 Count	102 Count
1775435442	111 Count	716 Count	102 Count
1775435419	111 Count	715 Count	102 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)