EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0MMC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0MMC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1765939151	317 Count	31 Count	14 Count
1765935566	316 Count	31 Count	14 Count
1765931963	315 Count	31 Count	14 Count
1765928360	314 Count	31 Count	14 Count
1765924757	313 Count	31 Count	14 Count
1765921154	312 Count	31 Count	14 Count
1765917551	311 Count	31 Count	14 Count
1765913965	310 Count	31 Count	14 Count
1765910362	308 Count	31 Count	14 Count
1765906759	307 Count	31 Count	14 Count
1765903156	306 Count	31 Count	14 Count
1765899553	305 Count	31 Count	14 Count
1765895950	304 Count	31 Count	14 Count
1765892365	302 Count	31 Count	14 Count
1765888762	301 Count	31 Count	14 Count
1765885159	300 Count	31 Count	14 Count
1765881556	299 Count	31 Count	14 Count
1765877953	298 Count	31 Count	14 Count
1765874350	296 Count	26 Count	13 Count
1765870764	294 Count	23 Count	12 Count
1765867161	292 Count	22 Count	11 Count
1765863558	291 Count	21 Count	11 Count
1765859955	290 Count	21 Count	11 Count
1765856352	289 Count	21 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)