EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

4K6EH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6EH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791503270	325 Count	514 Count	166 Count
1791502366	323 Count	511 Count	165 Count
1791501463	321 Count	508 Count	164 Count
1791500560	319 Count	505 Count	163 Count
1791499656	317 Count	503 Count	162 Count
1791498753	314 Count	501 Count	160 Count
1791497849	311 Count	499 Count	158 Count
1791496946	307 Count	496 Count	155 Count
1791496042	304 Count	494 Count	153 Count
1791495139	301 Count	492 Count	151 Count
1791494235	299 Count	491 Count	150 Count
1791493332	297 Count	487 Count	149 Count
1791492428	295 Count	484 Count	148 Count
1791491525	293 Count	479 Count	147 Count
1791490706	291 Count	476 Count	146 Count
1791489803	289 Count	472 Count	145 Count
1791488899	287 Count	469 Count	144 Count
1791487996	285 Count	465 Count	143 Count
1791487093	283 Count	463 Count	142 Count
1791486189	281 Count	459 Count	141 Count
1791485286	279 Count	456 Count	140 Count
1791484382	277 Count	454 Count	139 Count
1791483479	275 Count	449 Count	138 Count
1791482575	273 Count	446 Count	137 Count
1791481672	271 Count	443 Count	136 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)