EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

4K6AG-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6AG-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1775503546	523 Count	216 Count	216 Count
1775502942	521 Count	215 Count	215 Count
1775502336	520 Count	215 Count	215 Count
1775501735	518 Count	214 Count	214 Count
1775501132	516 Count	213 Count	213 Count
1775500529	515 Count	213 Count	213 Count
1775499300	512 Count	211 Count	211 Count
1775498697	510 Count	210 Count	210 Count
1775498093	509 Count	210 Count	210 Count
1775495681	498 Count	203 Count	203 Count
1775495074	496 Count	202 Count	202 Count
1775493869	493 Count	201 Count	201 Count
1775493269	491 Count	200 Count	200 Count
1775492660	489 Count	199 Count	199 Count
1775492060	487 Count	198 Count	198 Count
1775491454	486 Count	198 Count	198 Count
1775490853	484 Count	197 Count	197 Count
1775490247	482 Count	196 Count	196 Count
1775489643	480 Count	195 Count	195 Count
1775489040	479 Count	195 Count	195 Count
1775488436	477 Count	194 Count	194 Count
1775487835	474 Count	192 Count	192 Count
1775486628	472 Count	192 Count	192 Count
1775485419	467 Count	189 Count	189 Count
1775484816	464 Count	187 Count	187 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)