EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1779479130	250 Count	823 Count
1779478527	249 Count	816 Count
1779477924	248 Count	813 Count
1779477320	247 Count	811 Count
1779476716	246 Count	804 Count
1779476112	245 Count	799 Count
1779475508	244 Count	797 Count
1779474905	243 Count	790 Count
1779474302	242 Count	785 Count
1779473698	241 Count	783 Count
1779473217	240 Count	779 Count
1779472613	239 Count	775 Count
1779472009	238 Count	771 Count
1779471406	237 Count	767 Count
1779470802	236 Count	764 Count
1779470199	235 Count	761 Count
1779469595	234 Count	759 Count
1779468992	233 Count	754 Count
1779468388	232 Count	751 Count
1779467785	231 Count	744 Count
1779467182	230 Count	740 Count
1779466578	229 Count	738 Count
1779465975	228 Count	736 Count
1779465371	227 Count	732 Count
1779464768	226 Count	729 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)