EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4CPM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4CPM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771570311	46 Count	82 Count	43 Count
1771568508	31 Count	53 Count	29 Count
1771566705	16 Count	33 Count	15 Count
1771564902	7 Count	14 Count	7 Count
1771563099	498 Count	1002 Count	399 Count
1771561295	491 Count	987 Count	393 Count
1771559492	481 Count	968 Count	384 Count
1771557689	474 Count	952 Count	378 Count
1771555886	464 Count	935 Count	369 Count
1771554120	456 Count	917 Count	362 Count
1771552317	448 Count	900 Count	355 Count
1771550513	439 Count	882 Count	347 Count
1771548710	431 Count	865 Count	340 Count
1771546907	422 Count	847 Count	332 Count
1771545104	414 Count	828 Count	325 Count
1771543301	405 Count	809 Count	317 Count
1771541497	397 Count	791 Count	310 Count
1771539694	389 Count	773 Count	303 Count
1771537891	380 Count	755 Count	295 Count
1771536087	373 Count	744 Count	289 Count
1771534284	372 Count	744 Count	289 Count
1771532519	371 Count	743 Count	289 Count
1771530716	370 Count	743 Count	289 Count
1771528912	369 Count	743 Count	289 Count
1771527109	368 Count	743 Count	289 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)