EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785090230	90 Count	152 Count	73 Count
1785089326	86 Count	146 Count	70 Count
1785088422	82 Count	140 Count	67 Count
1785087518	77 Count	131 Count	63 Count
1785086713	72 Count	124 Count	59 Count
1785085809	67 Count	116 Count	55 Count
1785084905	62 Count	107 Count	51 Count
1785084001	56 Count	97 Count	46 Count
1785083097	50 Count	90 Count	41 Count
1785082193	45 Count	80 Count	37 Count
1785081289	40 Count	70 Count	33 Count
1785080385	35 Count	63 Count	29 Count
1785079480	30 Count	54 Count	25 Count
1785078576	24 Count	46 Count	20 Count
1785077672	18 Count	37 Count	15 Count
1785076768	13 Count	28 Count	11 Count
1785075864	10 Count	20 Count	9 Count
1785074960	5 Count	13 Count	5 Count
1785074060	654 Count	1040 Count	582 Count
1785073152	634 Count	989 Count	563 Count
1785072248	589 Count	939 Count	519 Count
1785071344	564 Count	913 Count	495 Count
1785070440	559 Count	905 Count	491 Count
1785069536	553 Count	896 Count	486 Count
1785068632	547 Count	886 Count	481 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)