EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ6OXF-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ6OXF-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766724657	439 Count	124 Count	109 Count
1766723757	438 Count	124 Count	109 Count
1766722855	437 Count	124 Count	109 Count
1766721955	436 Count	124 Count	109 Count
1766721054	435 Count	124 Count	109 Count
1766720154	434 Count	124 Count	109 Count
1766719254	433 Count	124 Count	109 Count
1766718352	432 Count	124 Count	109 Count
1766717452	431 Count	124 Count	109 Count
1766716551	430 Count	124 Count	109 Count
1766715650	429 Count	124 Count	109 Count
1766714750	428 Count	123 Count	109 Count
1766713848	427 Count	123 Count	109 Count
1766712948	426 Count	123 Count	109 Count
1766712062	425 Count	123 Count	109 Count
1766711161	424 Count	123 Count	109 Count
1766710260	423 Count	123 Count	109 Count
1766709360	422 Count	123 Count	109 Count
1766708459	421 Count	123 Count	109 Count
1766707558	420 Count	122 Count	109 Count
1766706658	419 Count	122 Count	109 Count
1766705757	418 Count	122 Count	109 Count
1766704856	417 Count	122 Count	109 Count
1766703955	416 Count	122 Count	109 Count
1766703055	415 Count	122 Count	109 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)