EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SZ1SV-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SZ1SV-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1779567587	358 Count	486 Count	347 Count
1779566684	331 Count	444 Count	321 Count
1779565781	303 Count	401 Count	294 Count
1779564878	274 Count	362 Count	266 Count
1779563975	242 Count	318 Count	235 Count
1779563070	210 Count	275 Count	204 Count
1779562167	179 Count	237 Count	174 Count
1779561264	150 Count	200 Count	146 Count
1779560361	118 Count	163 Count	115 Count
1779559457	88 Count	126 Count	86 Count
1779558554	59 Count	84 Count	58 Count
1779557651	30 Count	45 Count	30 Count
1779556748	690 Count	1019 Count	667 Count
1779555843	661 Count	980 Count	639 Count
1779554939	634 Count	935 Count	613 Count
1779554037	606 Count	892 Count	586 Count
1779553131	575 Count	845 Count	556 Count
1779552228	545 Count	806 Count	527 Count
1779551327	518 Count	761 Count	501 Count
1779550422	495 Count	734 Count	479 Count
1779549519	462 Count	691 Count	447 Count
1779548616	430 Count	643 Count	416 Count
1779547713	408 Count	598 Count	395 Count
1779546809	379 Count	559 Count	367 Count
1779545906	349 Count	516 Count	338 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)