EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787542969	176 Count	667 Count	160 Count
1787541168	162 Count	611 Count	147 Count
1787539363	149 Count	566 Count	135 Count
1787537560	137 Count	515 Count	124 Count
1787535757	121 Count	458 Count	109 Count
1787533954	106 Count	406 Count	95 Count
1787532151	95 Count	363 Count	85 Count
1787526742	57 Count	209 Count	50 Count
1787524973	41 Count	159 Count	39 Count
1787523170	26 Count	105 Count	25 Count
1787521367	12 Count	53 Count	12 Count
1787519564	219 Count	1021 Count	197 Count
1787517760	204 Count	957 Count	183 Count
1787515958	190 Count	899 Count	170 Count
1787512352	163 Count	788 Count	145 Count
1787510549	148 Count	738 Count	131 Count
1787505139	109 Count	577 Count	95 Count
1787503370	93 Count	522 Count	84 Count
1787501567	84 Count	455 Count	76 Count
1787499764	74 Count	406 Count	67 Count
1787497961	64 Count	347 Count	58 Count
1787496158	56 Count	298 Count	51 Count
1787494355	46 Count	242 Count	42 Count
1787492552	38 Count	183 Count	35 Count
1787490749	28 Count	133 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)