EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791451987	467 Count	377 Count	269 Count
1791450186	465 Count	376 Count	268 Count
1791448385	462 Count	374 Count	266 Count
1791446585	460 Count	373 Count	265 Count
1791444784	458 Count	372 Count	264 Count
1791442984	456 Count	371 Count	263 Count
1791441183	454 Count	370 Count	262 Count
1791439382	451 Count	368 Count	260 Count
1791437582	449 Count	366 Count	259 Count
1791435781	445 Count	363 Count	256 Count
1791433987	437 Count	360 Count	253 Count
1791432186	433 Count	357 Count	250 Count
1791430386	428 Count	351 Count	246 Count
1791428585	424 Count	348 Count	243 Count
1791426785	420 Count	345 Count	240 Count
1791424984	417 Count	342 Count	238 Count
1791423183	414 Count	340 Count	236 Count
1791421383	411 Count	338 Count	234 Count
1791419582	409 Count	336 Count	233 Count
1791417781	406 Count	334 Count	231 Count
1791415981	403 Count	332 Count	229 Count
1791414180	400 Count	329 Count	227 Count
1791412386	387 Count	317 Count	219 Count
1791410586	365 Count	287 Count	198 Count
1791408785	338 Count	250 Count	172 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)