EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1771578661	525 Count	932 Count	285 Count
1771575067	523 Count	928 Count	285 Count
1771571466	520 Count	922 Count	284 Count
1771567865	513 Count	912 Count	279 Count
1771564263	506 Count	902 Count	274 Count
1771560662	498 Count	880 Count	268 Count
1771557060	495 Count	875 Count	267 Count
1771553466	492 Count	868 Count	266 Count
1771549865	489 Count	862 Count	265 Count
1771546263	487 Count	856 Count	265 Count
1771542662	483 Count	849 Count	263 Count
1771539060	479 Count	843 Count	261 Count
1771535459	475 Count	836 Count	259 Count
1771531866	445 Count	796 Count	231 Count
1771528265	442 Count	792 Count	230 Count
1771524663	439 Count	786 Count	229 Count
1771521062	435 Count	779 Count	227 Count
1771517460	426 Count	760 Count	220 Count
1771513859	410 Count	738 Count	206 Count
1771510265	407 Count	731 Count	205 Count
1771506664	403 Count	720 Count	203 Count
1771503062	399 Count	706 Count	201 Count
1771499461	395 Count	698 Count	199 Count
1771495860	391 Count	691 Count	197 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)