EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762825516	651 Count	42 Count
1762823714	650 Count	42 Count
1762821914	649 Count	42 Count
1762820113	648 Count	42 Count
1762818312	647 Count	42 Count
1762816511	646 Count	42 Count
1762814711	645 Count	42 Count
1762812918	644 Count	42 Count
1762811117	643 Count	42 Count
1762809317	642 Count	42 Count
1762807516	641 Count	42 Count
1762805715	640 Count	42 Count
1762803914	639 Count	42 Count
1762802113	638 Count	42 Count
1762800313	637 Count	42 Count
1762798512	636 Count	42 Count
1762796711	635 Count	42 Count
1762794910	634 Count	42 Count
1762793109	633 Count	42 Count
1762791320	632 Count	42 Count
1762789519	631 Count	42 Count
1762787718	630 Count	42 Count
1762785917	629 Count	42 Count
1762784116	628 Count	42 Count
1762782315	627 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)