EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771570776	284 Count	649 Count	118 Count
1771568984	282 Count	646 Count	117 Count
1771567183	280 Count	640 Count	116 Count
1771565382	278 Count	637 Count	115 Count
1771563581	276 Count	634 Count	114 Count
1771561780	274 Count	631 Count	113 Count
1771559980	273 Count	629 Count	113 Count
1771558179	272 Count	627 Count	113 Count
1771556378	271 Count	625 Count	113 Count
1771554577	270 Count	623 Count	113 Count
1771552776	269 Count	621 Count	113 Count
1771550975	268 Count	619 Count	113 Count
1771547385	266 Count	610 Count	113 Count
1771545584	265 Count	608 Count	113 Count
1771543783	264 Count	606 Count	113 Count
1771541982	263 Count	604 Count	113 Count
1771540181	262 Count	602 Count	113 Count
1771538380	261 Count	600 Count	113 Count
1771536578	260 Count	598 Count	113 Count
1771534778	259 Count	596 Count	113 Count
1771532977	258 Count	594 Count	113 Count
1771525782	254 Count	581 Count	113 Count
1771523982	253 Count	579 Count	113 Count
1771522181	252 Count	577 Count	113 Count
1771520381	251 Count	575 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)