EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR1NRD-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR1NRD-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1766745084	803 Count	327 Count
1766744484	802 Count	326 Count
1766743883	801 Count	325 Count
1766743282	800 Count	325 Count
1766742681	799 Count	324 Count
1766742081	798 Count	323 Count
1766741513	797 Count	323 Count
1766740912	796 Count	322 Count
1766740312	795 Count	321 Count
1766739711	794 Count	321 Count
1766739110	793 Count	320 Count
1766738509	792 Count	319 Count
1766737909	791 Count	319 Count
1766737308	790 Count	318 Count
1766736707	789 Count	317 Count
1766736106	788 Count	317 Count
1766735506	787 Count	316 Count
1766734905	786 Count	315 Count
1766734304	785 Count	315 Count
1766733703	784 Count	314 Count
1766733102	783 Count	313 Count
1766732501	782 Count	313 Count
1766731901	781 Count	312 Count
1766731300	780 Count	311 Count
1766730699	779 Count	311 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)