EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790097161	67 Count	120 Count	6 Count
1790096560	60 Count	109 Count	6 Count
1790095959	54 Count	97 Count	5 Count
1790095359	46 Count	88 Count	4 Count
1790094758	41 Count	70 Count	4 Count
1790094157	33 Count	59 Count	3 Count
1790093557	27 Count	48 Count	2 Count
1790092956	18 Count	33 Count	2 Count
1790092356	12 Count	20 Count	1 Count
1790091755	4 Count	9 Count	0 Count
1790091154	191 Count	1001 Count	32 Count
1790090554	183 Count	989 Count	31 Count
1790089953	178 Count	979 Count	30 Count
1790089352	174 Count	968 Count	30 Count
1790088752	170 Count	945 Count	29 Count
1790088151	165 Count	907 Count	28 Count
1790087550	162 Count	875 Count	28 Count
1790086950	156 Count	822 Count	27 Count
1790086349	151 Count	785 Count	25 Count
1790085748	147 Count	745 Count	25 Count
1790085148	139 Count	702 Count	24 Count
1790084547	133 Count	666 Count	23 Count
1790083947	129 Count	633 Count	23 Count
1790083346	121 Count	588 Count	22 Count
1790082745	110 Count	554 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)