EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791506211	881 Count	618 Count	466 Count
1791484612	842 Count	591 Count	443 Count
1791482848	839 Count	589 Count	441 Count
1791481044	836 Count	587 Count	439 Count
1791472028	819 Count	573 Count	429 Count
1791470225	816 Count	571 Count	427 Count
1791468421	813 Count	568 Count	425 Count
1791466618	810 Count	564 Count	423 Count
1791464815	807 Count	562 Count	421 Count
1791463011	805 Count	561 Count	420 Count
1791461249	802 Count	558 Count	418 Count
1791459445	799 Count	555 Count	416 Count
1791457642	796 Count	552 Count	414 Count
1791455839	792 Count	549 Count	412 Count
1791454036	789 Count	546 Count	410 Count
1791452232	786 Count	543 Count	408 Count
1791450429	783 Count	541 Count	406 Count
1791448626	780 Count	539 Count	404 Count
1791446822	777 Count	537 Count	402 Count
1791445019	772 Count	534 Count	400 Count
1791443215	769 Count	532 Count	398 Count
1791441411	766 Count	530 Count	396 Count
1791439651	763 Count	527 Count	394 Count
1791437847	760 Count	524 Count	392 Count
1791436043	757 Count	522 Count	391 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)