EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

ON3RIP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON3RIP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1775500115	674 Count	928 Count
1775499212	658 Count	901 Count
1775498308	640 Count	883 Count
1775497405	624 Count	850 Count
1775496501	606 Count	827 Count
1775495597	590 Count	798 Count
1775494693	570 Count	780 Count
1775493790	550 Count	760 Count
1775492884	532 Count	733 Count
1775491981	518 Count	719 Count
1775491077	499 Count	703 Count
1775490174	486 Count	677 Count
1775489271	470 Count	624 Count
1775488449	455 Count	589 Count
1775487545	439 Count	556 Count
1775486642	423 Count	535 Count
1775485738	405 Count	516 Count
1775484835	391 Count	499 Count
1775483932	376 Count	474 Count
1775483028	362 Count	435 Count
1775482124	341 Count	419 Count
1775481221	327 Count	399 Count
1775480318	312 Count	380 Count
1775479415	295 Count	359 Count
1775478512	277 Count	328 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)