EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3KON-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766737316	147 Count	867 Count	100 Count
1766736415	143 Count	851 Count	97 Count
1766735514	140 Count	832 Count	95 Count
1766734613	134 Count	807 Count	90 Count
1766733713	130 Count	780 Count	87 Count
1766732812	127 Count	769 Count	85 Count
1766731911	124 Count	757 Count	83 Count
1766731010	121 Count	734 Count	81 Count
1766730109	118 Count	713 Count	79 Count
1766729208	114 Count	701 Count	76 Count
1766728307	111 Count	693 Count	74 Count
1766727406	108 Count	679 Count	72 Count
1766726505	105 Count	666 Count	70 Count
1766725604	102 Count	653 Count	68 Count
1766724704	99 Count	608 Count	66 Count
1766723803	96 Count	589 Count	64 Count
1766722902	93 Count	576 Count	62 Count
1766722025	90 Count	562 Count	60 Count
1766721124	87 Count	543 Count	58 Count
1766720223	84 Count	525 Count	56 Count
1766719323	81 Count	506 Count	54 Count
1766718421	78 Count	489 Count	52 Count
1766717520	75 Count	472 Count	50 Count
1766716619	72 Count	451 Count	48 Count
1766715718	69 Count	439 Count	46 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)