EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787534914	134 Count	252 Count	69 Count
1787534610	131 Count	247 Count	67 Count
1787534305	129 Count	239 Count	66 Count
1787534001	128 Count	231 Count	66 Count
1787533697	124 Count	224 Count	63 Count
1787533393	121 Count	219 Count	61 Count
1787533088	119 Count	211 Count	60 Count
1787532784	117 Count	208 Count	59 Count
1787532479	114 Count	196 Count	57 Count
1787532174	113 Count	194 Count	57 Count
1787531870	111 Count	192 Count	56 Count
1787531566	108 Count	188 Count	54 Count
1787531261	107 Count	182 Count	54 Count
1787530957	103 Count	178 Count	51 Count
1787530652	101 Count	172 Count	50 Count
1787530348	100 Count	171 Count	50 Count
1787530044	98 Count	168 Count	49 Count
1787529739	96 Count	163 Count	48 Count
1787529435	94 Count	157 Count	47 Count
1787529130	91 Count	152 Count	45 Count
1787528826	89 Count	150 Count	44 Count
1787528522	88 Count	148 Count	44 Count
1787528217	86 Count	140 Count	43 Count
1787527913	84 Count	137 Count	42 Count
1787527609	82 Count	133 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)