EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791448472	43 Count	246 Count	42 Count
1791446672	16 Count	110 Count	16 Count
1791443070	240 Count	945 Count	228 Count
1791441270	223 Count	856 Count	212 Count
1791439469	208 Count	788 Count	198 Count
1791435868	173 Count	574 Count	165 Count
1791434067	148 Count	469 Count	144 Count
1791432267	119 Count	364 Count	116 Count
1791430466	86 Count	271 Count	84 Count
1791428665	58 Count	189 Count	57 Count
1791426865	28 Count	98 Count	28 Count
1791425064	345 Count	1004 Count	331 Count
1791423263	307 Count	905 Count	294 Count
1791419678	242 Count	723 Count	235 Count
1791417877	209 Count	630 Count	203 Count
1791416077	177 Count	547 Count	172 Count
1791414276	151 Count	464 Count	147 Count
1791412475	123 Count	380 Count	120 Count
1791410674	89 Count	283 Count	87 Count
1791408873	54 Count	179 Count	53 Count
1791407073	25 Count	93 Count	25 Count
1791405272	201 Count	1083 Count	180 Count
1791403471	184 Count	978 Count	164 Count
1791401671	160 Count	878 Count	141 Count
1791399870	142 Count	781 Count	124 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)