EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

VK3XEM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK3XEM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775525587	681 Count	254 Count	254 Count
1775524683	679 Count	253 Count	253 Count
1775523779	677 Count	252 Count	252 Count
1775522875	675 Count	251 Count	251 Count
1775521971	673 Count	250 Count	250 Count
1775521067	671 Count	249 Count	249 Count
1775520163	669 Count	248 Count	248 Count
1775519259	667 Count	247 Count	247 Count
1775518355	665 Count	246 Count	246 Count
1775517451	663 Count	245 Count	245 Count
1775516546	661 Count	244 Count	244 Count
1775515740	659 Count	243 Count	243 Count
1775514835	657 Count	242 Count	242 Count
1775513931	655 Count	241 Count	241 Count
1775513027	653 Count	240 Count	240 Count
1775512123	651 Count	239 Count	239 Count
1775511219	649 Count	238 Count	238 Count
1775510315	647 Count	237 Count	237 Count
1775509411	645 Count	236 Count	236 Count
1775508507	643 Count	235 Count	235 Count
1775507602	641 Count	234 Count	234 Count
1775506698	639 Count	233 Count	233 Count
1775505794	637 Count	232 Count	232 Count
1775504890	635 Count	231 Count	231 Count
1775503986	633 Count	230 Count	230 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)