EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

9W8ASH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9W8ASH-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1779609074	250 Count	891 Count	197 Count
1779607272	204 Count	832 Count	182 Count
1779605465	164 Count	764 Count	164 Count
1779605456	164 Count	764 Count	164 Count
1779604041	148 Count	721 Count	148 Count
1779602241	109 Count	625 Count	109 Count
1779600441	92 Count	540 Count	92 Count
1779598641	76 Count	484 Count	76 Count
1779596841	61 Count	408 Count	61 Count
1779595041	43 Count	373 Count	43 Count
1779593240	29 Count	315 Count	29 Count
1779591434	16 Count	266 Count	16 Count
1779589634	0 Count	232 Count	0 Count
1779589561	0 Count	231 Count	0 Count
1779587761	0 Count	171 Count	0 Count
1779585961	0 Count	107 Count	0 Count
1779584161	0 Count	51 Count	0 Count
1779582361	0 Count	1059 Count	0 Count
1779580561	0 Count	992 Count	0 Count
1779578761	0 Count	912 Count	0 Count
1779577024	0 Count	861 Count	0 Count
1779575224	0 Count	818 Count	0 Count
1779573424	0 Count	774 Count	0 Count
1779571624	0 Count	721 Count	0 Count
1779569824	0 Count	656 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)