EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791456890	49 Count	924 Count
1791455087	48 Count	891 Count
1791453284	45 Count	841 Count
1791451480	44 Count	801 Count
1791449716	43 Count	774 Count
1791447913	42 Count	750 Count
1791446109	39 Count	717 Count
1791444306	38 Count	694 Count
1791442502	37 Count	666 Count
1791440699	36 Count	638 Count
1791438895	34 Count	610 Count
1791437092	33 Count	576 Count
1791435288	32 Count	548 Count
1791433484	28 Count	518 Count
1791431681	25 Count	484 Count
1791429878	24 Count	436 Count
1791428116	23 Count	386 Count
1791426312	22 Count	363 Count
1791424508	18 Count	330 Count
1791422705	17 Count	311 Count
1791420902	16 Count	270 Count
1791419098	15 Count	250 Count
1791417294	12 Count	232 Count
1791415491	11 Count	208 Count
1791413688	10 Count	184 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)