EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1APG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1APG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771582138	395 Count	607 Count	141 Count
1771580338	395 Count	607 Count	141 Count
1771578538	395 Count	607 Count	141 Count
1771576738	395 Count	607 Count	141 Count
1771574938	395 Count	607 Count	141 Count
1771573137	395 Count	607 Count	141 Count
1771571337	395 Count	607 Count	141 Count
1771569537	395 Count	607 Count	141 Count
1771567737	395 Count	607 Count	141 Count
1771565937	395 Count	607 Count	141 Count
1771564137	395 Count	607 Count	141 Count
1771562337	395 Count	607 Count	141 Count
1771560537	395 Count	607 Count	141 Count
1771558737	395 Count	607 Count	141 Count
1771556937	395 Count	607 Count	141 Count
1771555137	395 Count	607 Count	141 Count
1771551537	395 Count	607 Count	141 Count
1771549737	395 Count	607 Count	141 Count
1771547937	395 Count	607 Count	141 Count
1771546137	395 Count	607 Count	141 Count
1771544337	395 Count	607 Count	141 Count
1771542537	395 Count	607 Count	141 Count
1771540737	395 Count	607 Count	141 Count
1771538937	395 Count	607 Count	141 Count
1771537137	395 Count	607 Count	141 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)