EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ST-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1758386962	652 Count	628 Count	628 Count
1758378167	647 Count	628 Count	628 Count
1758376486	627 Count	609 Count	609 Count
1758374805	597 Count	580 Count	580 Count
1758369762	478 Count	464 Count	464 Count
1758368081	429 Count	416 Count	416 Count
1758366400	400 Count	388 Count	388 Count
1758364719	332 Count	321 Count	321 Count
1758361609	276 Count	271 Count	271 Count
1758359928	217 Count	213 Count	213 Count
1758358247	165 Count	162 Count	162 Count
1758356566	129 Count	127 Count	127 Count
1758354885	80 Count	79 Count	79 Count
1758349842	984 Count	953 Count	953 Count
1758348161	942 Count	912 Count	912 Count
1758346480	880 Count	851 Count	851 Count
1758344799	831 Count	803 Count	803 Count
1758343118	787 Count	760 Count	760 Count
1758341437	751 Count	725 Count	725 Count
1758340008	676 Count	655 Count	655 Count
1758338327	640 Count	620 Count	620 Count
1758336646	600 Count	581 Count	581 Count
1758334965	571 Count	553 Count	553 Count
1758333284	542 Count	525 Count	525 Count
1758331603	516 Count	500 Count	500 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)