EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IZ7EXI-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ7EXI-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1758364891	175 Count	992 Count
1758363985	174 Count	988 Count
1758363079	173 Count	985 Count
1758362173	172 Count	982 Count
1758361267	171 Count	978 Count
1758360360	170 Count	975 Count
1758359599	169 Count	973 Count
1758358693	168 Count	969 Count
1758357787	167 Count	966 Count
1758356881	166 Count	963 Count
1758355975	165 Count	959 Count
1758355068	164 Count	956 Count
1758354162	163 Count	952 Count
1758353256	162 Count	949 Count
1758352350	161 Count	945 Count
1758351443	160 Count	942 Count
1758350537	159 Count	939 Count
1758349631	158 Count	935 Count
1758348725	157 Count	932 Count
1758347819	156 Count	928 Count
1758346912	155 Count	925 Count
1758346006	154 Count	922 Count
1758345100	153 Count	918 Count
1758344194	152 Count	915 Count
1758343287	151 Count	911 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)