EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1766730462	235 Count	845 Count	193 Count
1766726861	230 Count	840 Count	189 Count
1766723260	225 Count	835 Count	185 Count
1766719660	220 Count	830 Count	181 Count
1766716059	215 Count	825 Count	177 Count
1766712457	210 Count	820 Count	173 Count
1766708856	202 Count	812 Count	166 Count
1766705255	197 Count	807 Count	162 Count
1766701655	192 Count	802 Count	158 Count
1766698054	187 Count	797 Count	154 Count
1766694452	182 Count	792 Count	150 Count
1766690851	177 Count	777 Count	146 Count
1766687250	169 Count	749 Count	139 Count
1766683649	164 Count	724 Count	135 Count
1766680049	159 Count	699 Count	131 Count
1766676447	154 Count	674 Count	127 Count
1766672846	149 Count	649 Count	123 Count
1766669245	144 Count	627 Count	119 Count
1766665644	136 Count	599 Count	112 Count
1766662043	131 Count	574 Count	108 Count
1766658442	126 Count	549 Count	104 Count
1766654842	121 Count	526 Count	100 Count
1766653246	120 Count	526 Count	100 Count
1766649645	115 Count	501 Count	96 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)