EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1779570925	154 Count	897 Count	96 Count
1779569125	151 Count	877 Count	94 Count
1779567324	148 Count	861 Count	92 Count
1779565523	145 Count	848 Count	90 Count
1779563723	142 Count	840 Count	88 Count
1779561922	139 Count	828 Count	86 Count
1779560121	136 Count	816 Count	84 Count
1779558320	134 Count	808 Count	83 Count
1779556520	132 Count	799 Count	82 Count
1779554719	129 Count	791 Count	80 Count
1779552918	128 Count	776 Count	80 Count
1779551126	127 Count	769 Count	80 Count
1779549325	124 Count	752 Count	78 Count
1779547524	121 Count	741 Count	76 Count
1779545723	120 Count	728 Count	76 Count
1779543923	119 Count	715 Count	76 Count
1779542122	116 Count	703 Count	74 Count
1779540321	114 Count	681 Count	73 Count
1779538520	113 Count	665 Count	73 Count
1779536720	110 Count	641 Count	71 Count
1779534919	106 Count	612 Count	68 Count
1779533118	105 Count	595 Count	68 Count
1779531318	103 Count	566 Count	67 Count
1779529525	100 Count	544 Count	65 Count
1779527725	96 Count	513 Count	62 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)