EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9SRC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9SRC-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1755249895	61 Count	881 Count
1755249295	60 Count	875 Count
1755248694	59 Count	865 Count
1755248093	58 Count	850 Count
1755247492	57 Count	839 Count
1755246892	56 Count	829 Count
1755246291	55 Count	817 Count
1755245690	54 Count	800 Count
1755245117	53 Count	788 Count
1755244516	52 Count	777 Count
1755243915	50 Count	764 Count
1755243315	48 Count	742 Count
1755242714	47 Count	728 Count
1755242113	45 Count	718 Count
1755241512	43 Count	692 Count
1755240912	41 Count	679 Count
1755240311	39 Count	663 Count
1755239710	38 Count	638 Count
1755239109	35 Count	622 Count
1755238509	33 Count	599 Count
1755237907	31 Count	576 Count
1755237306	30 Count	551 Count
1755236706	28 Count	531 Count
1755236105	26 Count	487 Count
1755235504	23 Count	474 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)