EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791454854	66 Count	117 Count	53 Count
1791454241	58 Count	100 Count	46 Count
1791453637	55 Count	90 Count	44 Count
1791453040	51 Count	78 Count	41 Count
1791452427	45 Count	68 Count	36 Count
1791451822	41 Count	63 Count	33 Count
1791451218	38 Count	59 Count	31 Count
1791450613	33 Count	52 Count	27 Count
1791450008	28 Count	43 Count	23 Count
1791449404	23 Count	35 Count	19 Count
1791448799	19 Count	28 Count	16 Count
1791448202	13 Count	20 Count	11 Count
1791447419	5 Count	10 Count	5 Count
1791446814	435 Count	1011 Count	343 Count
1791446210	430 Count	994 Count	339 Count
1791444998	420 Count	960 Count	331 Count
1791444606	418 Count	948 Count	330 Count
1791444009	415 Count	930 Count	328 Count
1791443397	408 Count	910 Count	322 Count
1791442792	404 Count	893 Count	319 Count
1791442195	402 Count	875 Count	318 Count
1791441582	393 Count	851 Count	310 Count
1791440978	390 Count	831 Count	308 Count
1791440372	386 Count	813 Count	305 Count
1791439768	381 Count	791 Count	301 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)