EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2SIX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762811050	12 Count	297 Count	12 Count
1762810450	12 Count	293 Count	12 Count
1762809850	12 Count	286 Count	12 Count
1762809250	12 Count	284 Count	12 Count
1762808650	12 Count	281 Count	12 Count
1762808050	12 Count	278 Count	12 Count
1762807450	12 Count	277 Count	12 Count
1762806850	12 Count	274 Count	12 Count
1762806250	12 Count	271 Count	12 Count
1762805650	12 Count	269 Count	12 Count
1762805050	12 Count	266 Count	12 Count
1762804450	12 Count	263 Count	12 Count
1762803850	12 Count	261 Count	12 Count
1762803250	12 Count	258 Count	12 Count
1762802650	12 Count	255 Count	12 Count
1762802050	12 Count	253 Count	12 Count
1762801450	12 Count	250 Count	12 Count
1762800849	12 Count	247 Count	12 Count
1762800250	12 Count	244 Count	12 Count
1762799650	12 Count	237 Count	12 Count
1762799050	12 Count	235 Count	12 Count
1762798450	12 Count	234 Count	12 Count
1762797850	12 Count	225 Count	12 Count
1762797250	12 Count	220 Count	12 Count
1762796650	12 Count	218 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)