EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9KFP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1783306151	213 Count	782 Count	149 Count
1783305250	209 Count	768 Count	146 Count
1783304350	206 Count	758 Count	144 Count
1783301648	195 Count	727 Count	136 Count
1783298945	185 Count	683 Count	129 Count
1783298045	182 Count	670 Count	127 Count
1783296243	175 Count	649 Count	122 Count
1783295343	171 Count	636 Count	119 Count
1783294442	169 Count	620 Count	118 Count
1783292641	162 Count	584 Count	113 Count
1783290839	155 Count	549 Count	108 Count
1783289940	151 Count	529 Count	105 Count
1783289038	148 Count	513 Count	103 Count
1783288138	144 Count	490 Count	100 Count
1783287237	142 Count	478 Count	99 Count
1783286336	138 Count	457 Count	96 Count
1783284535	131 Count	422 Count	91 Count
1783283634	128 Count	408 Count	89 Count
1783282733	125 Count	385 Count	87 Count
1783281833	123 Count	369 Count	86 Count
1783280932	119 Count	348 Count	83 Count
1783280031	116 Count	335 Count	81 Count
1783279131	112 Count	318 Count	78 Count
1783278231	109 Count	305 Count	76 Count
1783277329	105 Count	291 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)