EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IW9GTR-DP Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-DP. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1754174903	339 Count	605 Count	282 Count
1754173695	319 Count	573 Count	264 Count
1754172487	308 Count	552 Count	255 Count
1754171279	300 Count	535 Count	249 Count
1754170072	294 Count	523 Count	245 Count
1754168864	283 Count	501 Count	236 Count
1754167795	271 Count	474 Count	226 Count
1754166587	262 Count	451 Count	219 Count
1754165379	252 Count	431 Count	211 Count
1754164171	238 Count	411 Count	199 Count
1754162963	233 Count	399 Count	196 Count
1754161755	221 Count	377 Count	186 Count
1754160547	208 Count	358 Count	175 Count
1754159340	184 Count	324 Count	153 Count
1754158132	176 Count	300 Count	147 Count
1754156924	169 Count	286 Count	142 Count
1754155716	161 Count	264 Count	136 Count
1754154508	141 Count	227 Count	118 Count
1754153301	126 Count	192 Count	105 Count
1754152093	113 Count	166 Count	95 Count
1754150885	100 Count	150 Count	84 Count
1754149677	82 Count	125 Count	69 Count
1754148469	70 Count	104 Count	59 Count
1754147262	53 Count	76 Count	46 Count
1754146207	41 Count	59 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)