EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790092161	253 Count	928 Count
1790090361	209 Count	764 Count
1790088560	153 Count	559 Count
1790086759	115 Count	388 Count
1790084966	57 Count	166 Count
1790083165	571 Count	1017 Count
1790081364	500 Count	846 Count
1790079564	428 Count	703 Count
1790077763	391 Count	641 Count
1790075962	344 Count	543 Count
1790074162	283 Count	446 Count
1790072361	235 Count	393 Count
1790070560	179 Count	285 Count
1790068760	124 Count	193 Count
1790066959	52 Count	83 Count
1790065158	3 Count	0 Count
1790063366	766 Count	952 Count
1790061564	715 Count	869 Count
1790059764	669 Count	814 Count
1790057963	628 Count	765 Count
1790056162	594 Count	731 Count
1790054362	562 Count	693 Count
1790052561	523 Count	659 Count
1790050760	490 Count	627 Count
1790048960	457 Count	598 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)