EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766737254	6 Count	36 Count
1766735453	5 Count	31 Count
1766733652	4 Count	24 Count
1766731852	3 Count	19 Count
1766730051	2 Count	14 Count
1766728250	1 Count	10 Count
1766726450	0 Count	4 Count
1766724649	57 Count	1001 Count
1766722848	56 Count	994 Count
1766721048	55 Count	990 Count
1766719247	54 Count	983 Count
1766717454	53 Count	978 Count
1766715654	52 Count	972 Count
1766713852	51 Count	968 Count
1766712052	50 Count	962 Count
1766710251	49 Count	954 Count
1766708450	48 Count	949 Count
1766706650	47 Count	945 Count
1766704849	46 Count	939 Count
1766703048	45 Count	935 Count
1766701248	44 Count	930 Count
1766699447	43 Count	925 Count
1766697646	42 Count	919 Count
1766695854	41 Count	911 Count
1766694053	40 Count	890 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)