EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762817273	279 Count	63 Count	29 Count
1762816372	270 Count	60 Count	27 Count
1762815471	265 Count	59 Count	26 Count
1762814571	254 Count	57 Count	25 Count
1762813670	250 Count	56 Count	25 Count
1762812769	243 Count	54 Count	25 Count
1762811869	237 Count	53 Count	25 Count
1762810968	230 Count	51 Count	25 Count
1762810066	224 Count	50 Count	24 Count
1762809165	215 Count	48 Count	24 Count
1762808265	211 Count	47 Count	24 Count
1762807364	203 Count	45 Count	23 Count
1762806463	196 Count	44 Count	23 Count
1762805563	187 Count	41 Count	21 Count
1762804662	183 Count	40 Count	21 Count
1762803761	172 Count	37 Count	19 Count
1762802860	165 Count	33 Count	16 Count
1762801960	157 Count	31 Count	16 Count
1762801059	146 Count	26 Count	11 Count
1762800175	139 Count	24 Count	11 Count
1762799274	135 Count	23 Count	11 Count
1762798373	126 Count	21 Count	11 Count
1762797473	120 Count	19 Count	10 Count
1762796572	112 Count	17 Count	10 Count
1762795671	106 Count	16 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)