EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787566295	968 Count	366 Count	151 Count
1787564368	966 Count	366 Count	151 Count
1787562442	964 Count	366 Count	151 Count
1787560515	962 Count	366 Count	151 Count
1787558588	958 Count	363 Count	149 Count
1787556661	954 Count	359 Count	147 Count
1787554735	951 Count	358 Count	146 Count
1787552808	949 Count	356 Count	146 Count
1787550881	946 Count	355 Count	145 Count
1787550470	944 Count	354 Count	144 Count
1787548543	941 Count	353 Count	143 Count
1787546617	938 Count	351 Count	142 Count
1787544690	934 Count	349 Count	140 Count
1787542763	931 Count	347 Count	139 Count
1787540836	928 Count	339 Count	138 Count
1787538910	926 Count	338 Count	138 Count
1787536983	923 Count	337 Count	137 Count
1787535056	921 Count	336 Count	137 Count
1787533129	919 Count	336 Count	137 Count
1787531203	916 Count	333 Count	136 Count
1787529276	912 Count	330 Count	134 Count
1787507269	880 Count	317 Count	126 Count
1787505343	878 Count	317 Count	126 Count
1787503416	876 Count	317 Count	126 Count
1787501489	874 Count	317 Count	126 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)