EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M0KNF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0KNF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1754179399	33 Count	653 Count
1754177596	32 Count	646 Count
1754175793	31 Count	641 Count
1754173990	30 Count	634 Count
1754172187	29 Count	629 Count
1754170420	28 Count	624 Count
1754168617	27 Count	618 Count
1754166814	26 Count	612 Count
1754165011	25 Count	606 Count
1754163208	24 Count	599 Count
1754161405	23 Count	594 Count
1754159602	22 Count	587 Count
1754157799	21 Count	580 Count
1754155996	20 Count	576 Count
1754154193	19 Count	570 Count
1754152390	18 Count	565 Count
1754150587	17 Count	557 Count
1754147893	16 Count	557 Count
1754146090	15 Count	543 Count
1754144287	14 Count	529 Count
1754142484	13 Count	484 Count
1754140681	12 Count	435 Count
1754138913	11 Count	371 Count
1754137110	10 Count	332 Count
1754135307	9 Count	314 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)