EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IW2HTZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW2HTZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1783310240	30 Count	362 Count
1783309337	29 Count	355 Count
1783308433	28 Count	340 Count
1783307525	27 Count	326 Count
1783306714	26 Count	310 Count
1783305814	25 Count	301 Count
1783304910	24 Count	289 Count
1783304006	23 Count	275 Count
1783303102	22 Count	262 Count
1783302194	21 Count	254 Count
1783301294	20 Count	244 Count
1783300386	19 Count	236 Count
1783299483	18 Count	225 Count
1783298582	17 Count	217 Count
1783297679	16 Count	204 Count
1783296775	15 Count	197 Count
1783295871	14 Count	185 Count
1783294967	13 Count	173 Count
1783294059	12 Count	163 Count
1783293159	11 Count	153 Count
1783292255	10 Count	140 Count
1783291351	9 Count	130 Count
1783290447	8 Count	117 Count
1783289543	7 Count	108 Count
1783288640	6 Count	84 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)