EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1779397240	794 Count	71 Count	38 Count
1779395440	793 Count	71 Count	38 Count
1779393639	791 Count	70 Count	37 Count
1779391838	788 Count	68 Count	35 Count
1779390038	786 Count	67 Count	34 Count
1779388237	785 Count	67 Count	34 Count
1779384642	779 Count	67 Count	34 Count
1779382841	778 Count	67 Count	34 Count
1779381041	777 Count	67 Count	34 Count
1779379240	776 Count	67 Count	34 Count
1779375639	774 Count	67 Count	34 Count
1779373839	773 Count	67 Count	34 Count
1779372038	772 Count	67 Count	34 Count
1779370237	770 Count	66 Count	33 Count
1779368437	769 Count	66 Count	33 Count
1779366636	768 Count	66 Count	33 Count
1779364841	763 Count	66 Count	33 Count
1779363041	762 Count	66 Count	33 Count
1779359440	760 Count	66 Count	33 Count
1779357639	759 Count	66 Count	33 Count
1779354038	757 Count	66 Count	33 Count
1779352238	756 Count	66 Count	33 Count
1779345035	752 Count	66 Count	33 Count
1779343240	747 Count	66 Count	33 Count
1779341440	746 Count	66 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)