EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790068405	709 Count	786 Count	61 Count
1790067804	708 Count	785 Count	61 Count
1790067202	707 Count	784 Count	61 Count
1790066600	706 Count	783 Count	61 Count
1790065999	705 Count	782 Count	61 Count
1790065398	704 Count	781 Count	61 Count
1790064798	703 Count	780 Count	61 Count
1790064197	702 Count	779 Count	61 Count
1790063596	701 Count	778 Count	61 Count
1790062995	700 Count	772 Count	61 Count
1790062394	699 Count	771 Count	61 Count
1790061793	698 Count	770 Count	61 Count
1790061192	697 Count	769 Count	61 Count
1790060592	696 Count	768 Count	61 Count
1790059991	695 Count	767 Count	61 Count
1790059390	694 Count	766 Count	61 Count
1790058789	693 Count	765 Count	61 Count
1790058188	692 Count	763 Count	61 Count
1790057587	691 Count	762 Count	61 Count
1790057017	686 Count	761 Count	61 Count
1790056417	685 Count	760 Count	61 Count
1790055816	684 Count	759 Count	61 Count
1790055215	683 Count	758 Count	61 Count
1790054614	682 Count	757 Count	61 Count
1790054013	681 Count	756 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)