EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1754179413	397 Count	786 Count
1754179113	396 Count	785 Count
1754178812	395 Count	783 Count
1754178512	394 Count	780 Count
1754178211	393 Count	779 Count
1754177911	392 Count	777 Count
1754177610	391 Count	774 Count
1754177310	390 Count	773 Count
1754177009	389 Count	767 Count
1754176748	384 Count	764 Count
1754176448	383 Count	763 Count
1754176147	382 Count	762 Count
1754175847	381 Count	758 Count
1754175546	380 Count	757 Count
1754175245	379 Count	756 Count
1754174945	378 Count	752 Count
1754174644	377 Count	751 Count
1754174344	376 Count	750 Count
1754174043	375 Count	746 Count
1754173743	374 Count	745 Count
1754173442	373 Count	744 Count
1754173141	372 Count	740 Count
1754172841	371 Count	739 Count
1754172540	370 Count	738 Count
1754172240	369 Count	734 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)