EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766731230	425 Count	719 Count	63 Count
1766729426	424 Count	714 Count	63 Count
1766727623	423 Count	710 Count	63 Count
1766725819	422 Count	708 Count	63 Count
1766724015	421 Count	705 Count	63 Count
1766722212	420 Count	701 Count	63 Count
1766720408	419 Count	698 Count	63 Count
1766718604	418 Count	695 Count	63 Count
1766716801	417 Count	692 Count	63 Count
1766714997	416 Count	689 Count	63 Count
1766713234	411 Count	685 Count	63 Count
1766711431	410 Count	683 Count	63 Count
1766709627	409 Count	680 Count	63 Count
1766707823	408 Count	675 Count	63 Count
1766706020	407 Count	670 Count	63 Count
1766704216	406 Count	666 Count	63 Count
1766702412	405 Count	661 Count	63 Count
1766700609	404 Count	658 Count	63 Count
1766698805	403 Count	656 Count	63 Count
1766697001	402 Count	652 Count	63 Count
1766695198	401 Count	623 Count	63 Count
1766693394	400 Count	621 Count	63 Count
1766691632	395 Count	619 Count	63 Count
1766689828	394 Count	615 Count	63 Count
1766688024	393 Count	613 Count	63 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)