EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762902390	44 Count	62 Count	30 Count
1762901484	41 Count	56 Count	28 Count
1762900579	38 Count	52 Count	26 Count
1762899810	35 Count	48 Count	24 Count
1762898904	32 Count	45 Count	22 Count
1762897999	29 Count	42 Count	20 Count
1762897093	26 Count	37 Count	18 Count
1762896186	23 Count	34 Count	16 Count
1762895281	20 Count	29 Count	14 Count
1762894375	17 Count	24 Count	12 Count
1762893470	14 Count	20 Count	10 Count
1762892564	11 Count	15 Count	8 Count
1762891659	8 Count	11 Count	6 Count
1762890753	5 Count	8 Count	4 Count
1762889847	2 Count	5 Count	2 Count
1762888942	500 Count	1001 Count	333 Count
1762888036	497 Count	996 Count	331 Count
1762887131	494 Count	993 Count	329 Count
1762886225	491 Count	987 Count	327 Count
1762885319	488 Count	984 Count	325 Count
1762884413	485 Count	981 Count	323 Count
1762883508	482 Count	976 Count	321 Count
1762882602	479 Count	972 Count	319 Count
1762881696	476 Count	968 Count	317 Count
1762880791	473 Count	962 Count	315 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)